From: Andrew H. <ham...@mc...> - 2006-02-16 19:29:06
|
On Thursday 16 February 2006 9:03 am, David P wrote: > I run a Hauppage BT848 based capture card, and I feed my Burle CCTV > camera into the composite port. > > No matter what I do, I cannot get motion to run at any resolution other > than 640x480. I can't go down in size or up. I always get a segfault. > > What am I doing wrong? > > If you need any details of the card, my drivers, motion version etc > please ask. I am tearing my hair out :) 640x480 is fine, but I have > really bad interlacing which ruins the picture quality from my CCTV > camera - not a cheap $20 cam off ebay. > > David, England. If you have a mask file that is 640x480, then Motion will probably segfault unless you remove it. I had the same problem and went crazing trying to figure out what was wrong, then realized I forgot to change my mask file. You could also try a Motion daily snapshot to use deinterlacing if you want the bigger picture size. Hope this helps. Sincerely, Andrew Hamilton |