[Motion-user] Hardware error, Input 8 same as input 0...?

[Rodney M. <ro...@me...>]

Hi to All on the MOTION list...

Excellent program! 

Recently upgraded from FC4 ==> F9 and all went well, installed the
latest version of motion Version 3.2.10.1 and all good!

Then...out of the blue camera 9 video is the same as camera 1.


>From /etc/modprobe.conf 

options bttv card=113,131,131,131,131

Not sure if this is OK or not...

Now the thread files are all good and being read properly, ie: If I
change the thread9.conf to input 7 it changes to camera 8, put it back
to input 8 and sure enough it displays camera 1.

This is a 16 camera card...so I tried input 9 and it is blank.

Running TVTIME allows selection of individual inputs and they all show
as they should including camera 9 (input 8), so it appears there is a
glitch with motion? TVTIME demonstrates the hardware is how it should
be.

Any ideas or clues out there?

Regards, Rod.

-- 
==============================================
Rodney Mitchell
Senior Technical Officer

Melecom
73 Fiveash Drive
Pasadena
South Australia     5042

www.melecom.com.au

VK5KFB
================================================


-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
Supported by melecom with a Fedora server.