On Raspberry Pi, image from Domoticz, after install Mochad according to the discription on this site, the following message after starting mochad:
mochad[2299] usb_claim_interface failed -6
lsusb says: Bus 001 Device 004: ID 0bc7:0001 X10 Wireless Technology, Inc. ActiveHome (ACPI-compliant).
Please help??
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Not certain what the second message has to do with the OP, but I am having the same issue. When using mochad I see Tx RF, Rx RF, Rx RFsec and Tx PL events, but NO Rx PL events! :(
I'm not certain, however, whether it even is capable of reporting these events?...
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
CM15pro won't anymore reveive any pl commands, sending commands works fine.
Any idea how to debug this?
On Raspberry Pi, image from Domoticz, after install Mochad according to the discription on this site, the following message after starting mochad:
mochad[2299] usb_claim_interface failed -6
lsusb says: Bus 001 Device 004: ID 0bc7:0001 X10 Wireless Technology, Inc. ActiveHome (ACPI-compliant).
Please help??
Not certain what the second message has to do with the OP, but I am having the same issue. When using mochad I see Tx RF, Rx RF, Rx RFsec and Tx PL events, but NO Rx PL events! :(
I'm not certain, however, whether it even is capable of reporting these events?...