From: Ron K. <Ro...@de...> - 2000-05-03 13:36:49
|
> > Ok, I think I understand now. The way mh runs today (we could change this, or > make it optional) is that it will log an unrcognized message whenever there is > incoming X10 data for a device that has not been coded in code files. > > If you defined an X10 item for A3, or set up a serial event to look for > XA3AJ (for on) and XA3AK (for off), these messages should go away. > > The checksum errors are typically caused by traffic on the powerline, so > should not be too common. > > Bruce I had a feeling that this was the case. Now that I know for sure, I will try to let Mh run for a while without serial handshaking the serial data. If that works ok, there is no need to alter the SerialPorts.pm Sorry for the misunderstanding. Everyday mh switches my porchlight on/off when expected so the CM11/serial works. Ron. |