From: Rick S. <mis...@co...> - 2005-03-27 18:47:05
|
Yeah, I believe the X10 troubleshooting guide for the CM11A is something like: If it stops working, unplug it, and plug it back in If that doesn't work, unplug it for 5 minutes and plug it back in an hour 12 hours a day etc. I did all that, called it in for RMA, and, about 2 weeks later before I shipped it back for not workingness, tried it again, and viola! it was fixed. Odd. Rick At 10:07 AM 3/27/2005, Kirk Bauer wrote: >So the other night all X10 stopped working in my house, even stuff that >did not go through Misterhouse. > >I got the old signal meter out to see what the signal levels looked like >and I was seeing repeated X10 signals over and over again (don't know >what they were sending as my meter does not tell me). > >Found out that unplugging my CM11A stopped it. So I left it unplugged >all night but that still didn't work. Then I remembered the batteries >that have been in there for like 5 years from before I used Misterhouse. >Took those out, plugged it back in, and everything is back to normal. > >So, somehow my CM11A got in a bad state or something that caused it to >repeatedly send X10 commands until it was fully reset. > >-- >Kirk Bauer <ki...@ka...> >http://linux.kaybee.org | www.autorpm.org | www.logwatch.org > > >------------------------------------------------------- >SF email is sponsored by - The IT Product Guide >Read honest & candid reviews on hundreds of IT Products from real users. >Discover which products truly live up to the hype. Start reading now. >http://ads.osdn.com/?ad_id=6595&alloc_id=14396&op=click >________________________________________________________ >To unsubscribe from this list, go to: >http://sourceforge.net/mail/?group_id=1365 Rick Steeves ri...@si... http://www.sinister.net |