From: Bruce W. <br...@mi...> - 2003-04-17 01:54:09
|
> I've got an MR26 that picks up X-10 RF signals in > addition to the CM11 that picks up X-10 PLC signals. > > I'd like to get MH to perform the same Bridging of RF signals to > the PLC. Currently when MH receives RF signals from the MR26 it's > not acting upon them and sending out PLC cmd via the CM11. I was > wondering what's suppose to be done. I vaguely recall it being > mentioned within the past couple of months. I just looked thru the > MH mailing list and for mr26 discussion and didn't see it. Here is an example from the comment at the top of lib/X10_MR26.pm: If you want to relay all the of the incoming RF data back out to the powerline, you can use this code: $Transmitter = new X10_Item; if ($state = state_now $Remote and $state =~ /^X/) { print_log "Relaying X10 data from the MR26: $state"; set $Transmitter $state; } You may want to limit this to not relay busy motion detectors. > Looking at the trace data it appears that MH thinks the RF cmds > have been acted upon and changes it's internal state to reflect > it's belief that the state has changed. I assume that this problem > has been resolved a while ago and thought it best to just ask > around before messing with it. I suspect the solution is something > simple. > > -piet Yes, I think by default, if you have a X10 or Serial_Item that matches any incoming MR26 data, it will get set to that matching state. Bruce |