Re: [Mauve-users] exited with error code: 2

[Aaron D. <aar...@ut...>]

Hi Eric,
what version of Mauve are you using?
All recent (e.g. in the past 5 years) builds have included 64-bit intel
support for Mac OS X. They work on OS X 10.7. There are powerpc versions
included in the 'fat' binaries. If you get the this snapshot:
http://gel.ahabs.wisc.edu/mauve/snapshots/2012/2012-02-03/MacOS/progressiveMauve.bz2
unzip and set the execute bit it should work. If not I wonder if your
system might have some unusual configuration that causes it to ignore
the intel components of fat binaries?

Best,
-Aaron


On Wed, 2014-05-21 at 21:37 +1000, Eric wrote:
> I have tried running a two-sequence alignment in progressiveMauve on a Mac OS X Lion 10.7.5, but get the message: "exited with error code: 2", followed by a Mac pop-up message: "You can't open the application progressiveMauve because PowerPC applications are no longer supported". Is it possible to run progressiveMauve with OS X 10.7? Anyone have any suggestions.
> 
> Thanks.

-- 
Aaron E. Darling, Ph.D.
Associate Professor, ithree institute
University of Technology Sydney
Australia

http://darlinglab.org
twitter: @koadman



UTS CRICOS Provider Code: 00099F
DISCLAIMER: This email message and any accompanying attachments may contain confidential information.
If you are not the intended recipient, do not read, use, disseminate, distribute or copy this message or
attachments. If you have received this message in error, please notify the sender immediately and delete
this message. Any views expressed in this message are those of the individual sender, except where the
sender expressly, and with authority, states them to be the views of the University of Technology Sydney.
Before opening any attachments, please check them for viruses and defects.

Think. Green. Do.

Please consider the environment before printing this email.