[matplotlib-devel] matplotlib 1.3.0rc4 (was: matplotlib 1.3.0rc3 tomorrow)

[Michael D. <md...@st...>]

I have made a new release candidate (1.3.0rc4) that fixes the following 
vs. 1.3.0rc3:

- It doesn't add a setup.cfg file to the tarball

- It doesn't install the KnownFailure nose plugin as a pkg_resources 
entry_point (this conflicted with IPython's plugin of the same name)

- We get a known failure from the pep8 test if pep8 isn't installed

Hopefully that's enough to get to the point of giving this release 
candidate some wider exposure before putting out a final release. We can 
use some sprint time at Scipy to get this release polished if desired 
and necessary, too.

Mike

On 06/19/2013 06:10 PM, Michael Droettboom wrote:
> On 06/19/2013 05:45 PM, Michael Droettboom wrote:
>> On 06/19/2013 05:03 PM, Russell E. Owen wrote:
>>> In article<51C...@st...>,
>>>   Michael Droettboom<md...@st...>  
>>>   wrote:
>>>
>>>> I have tagged a 1.3.0rc3 and uploaded a tarball to Sourceforge.
>>>>
>>>> We may not get all the binaries up in the next little while, so I'll
>>>> wait for those and then make an announcement on matplotlib-users.  After
>>>> a couple of weeks, assuming no serious problems, we'll be ready for
>>>> 1.3.0 final.
>>>>
>>>> Thanks again to everyone for their help with this release!
>>> I have uploaded the MacOS 10.6 64-bit binary. However, there were a few
>>> unit test failures, including the font complaint that I first saw in an
>>> earlier 1.3.0 prerelease, plus one about pep8 that I've never seen
>>> before.
>>
>> The font issue was reportedly fixed by 9ccacff 
>> <https://github.com/pwuertz/matplotlib/commit/9ccacffe81e0d4a48e4a4b19064460b94c6f77c9>, 
>> but apparently not.  I'll ping Peter Wuertz about that.
> My bad.  It was determined that this was too difficult to fix at the 
> moment.  See issue https://github.com/matplotlib/matplotlib/pull/2117.
>
> Let's just ignore this for now -- for finesse we can trap this case 
> and mark it as "known fail", but I don't think that needs to hold 
> things up for now.
>
> Mike
>
>
> ------------------------------------------------------------------------------
> This SF.net email is sponsored by Windows:
>
> Build for Windows Store.
>
> http://p.sf.net/sfu/windows-dev2dev
>
>
> _______________________________________________
> Matplotlib-devel mailing list
> Mat...@li...
> https://lists.sourceforge.net/lists/listinfo/matplotlib-devel