overplotting surfaces created with Face command not working

[Zigman]

Hi there,
I am trying to create a plot with gray-scale hexagons (using the Face
command), and then overplot that with a circle. If I don't plot the
hexagons the circle shows up fine. However, if I plot the hexagons and then
the circle, the circle does not show up. Any suggestions?

Thanks in advance,
Andreas

--
Dr. Andreas Ritter
Graduate Institute of Astronomy
National Central University
Jhongli City
Taiwan (R.O.C.)

---

A history of the Universe - the short story:
Hydrogen is a light, odourless gas which, given enough time, turns into
people.

[Alexey Balakin]

Hi,
Most probably yours faces (hexagons) are located higher than circle, and circle is just hidden. Try to change its z-coordinate(s).