RE: [Madwifi-devel] How to get madwifi work on AR2313a?
Status: Beta
Brought to you by:
otaku
From: Gursel M. <gu...@ai...> - 2005-10-28 12:08:58
|
After some research, I discovered that I should use AHB bus instead of = PCI. I understood that, AHB bus support is supplied by = "/ath/if_ath_ahb.c" file in new-codebase. I did needed costumization to = Makefile for BUS selection and compiled the source but I still get the = following boot message: ------------------------------------------------ ath_hal: 0.9.15.1 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, = RF5413) ath_rate_onoe: 1.0 ath_ahb: 0.9.4.5 (Atheros/multi-bss) wifi%d: unable to attach hardware; HAL status 1 ath_ahb: No devices found, driver not installed. wlan: 0.8.4.2 (Atheros/multi-bss) wlan: mac acl policy registered ------------------------------------------------- =20 So, this time I get 2 extra lines by using AHB bus definition but there = is still something missing. Is there any one, who has experiance on implementing Madwifi on an = Atheros SoC in this mailing group? =20 Regards, G=FCrsel MUTLU =20 ________________________________ From: mad...@li... = [mailto:mad...@li...] On Behalf Of Gursel = Mutlu Sent: Wednesday, October 26, 2005 5:27 PM To: mad...@li...; = mad...@li... Subject: [Madwifi-devel] How to get madwifi work on AR2313a? Hi, I have some trouble to get madwifi work on an embedded system which has = AR2313A-00 chip on it. The CPU is "MIPS 4Kc V0.10" and kernel is = "2.4.27". I tried with both old and new codebases but I still have = problems. I costumized the kernel of embedded linux for built-in "Atheros = 802.11(a/b/g) PCI/Cardbus support" using "/patch/2.4/install.sh" script = and compiled it. After loading kernel file to board, I got the only = following boot messages: ------------------ ath_hal: 0.9.15.1 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, = RF5413) ath_rate_onoe: 1.0 ath_pci: 0.9.4.5 (Atheros/multi-bss) wlan: 0.8.4.2 (Atheros/multi-bss) wlan: mac acl policy registered ------------------ but I didn't get any message that tells about recognized device. As you = know some information about irq, rates,etc. are expected to be printed = after these lines. So, I can't use madwifi. G=FCrsel MUTLU |