From: Tim <ter...@ro...> - 2009-02-03 05:13:33
|
On February 2, 2009 08:14:49 pm Geoff Beasley wrote: > The program change pane in the piano roll still doesn't allow the adding of > nodes. Am i missing something or is it still broken? would be great to have > working properly. > > best, > > g. You can edit the program graph but the range of values is so high 0 - 2097151 that it's hard to draw the value you want, and it's very impractical. That was why I left out the adjustment knob for it - too high range. I will try again to enable the adjustment knob for only the program byte (0 - 127), and correct the graph so that it, too, only shows 0 - 127. In the mean time did you know you can 'dial in' a program in the track info panel, then hit that little "Rec" button (just above H-Bank), and it will instantly show up in the graph? Actually I just noticed a bug - it shows up in the graph only if there is no existing value on the graph at the given time, after that the graph won't budge that particular graph 'bar' when you hit "Rec". And yet the values HAVE been recorded and play back OK, which is a good thing. I will look into it... Otherwise you can use the event list editor and manually edit program changes. |