Coul´d you please explain a little how to read / interpret the graph obtained whit the --showanalyzerconsole ??
I knew about it in a comment from you in the forum.
It looks very intresting and helpfull, but I am not sure how to understand it.
Thanks a lot!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
We are running jitter buffers of each supported size in the background. For each of these buffers, we calculate a block error rate (i.e. how many over-/underruns are happening). Usually the smaller buffers (which are on the left side of the graph) have higher error rates. The lines are the limits until the auto jitter buffer algorithm changes its size.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
High Corrados,
Coul´d you please explain a little how to read / interpret the graph obtained whit the --showanalyzerconsole ??
I knew about it in a comment from you in the forum.
It looks very intresting and helpfull, but I am not sure how to understand it.
Thanks a lot!
We are running jitter buffers of each supported size in the background. For each of these buffers, we calculate a block error rate (i.e. how many over-/underruns are happening). Usually the smaller buffers (which are on the left side of the graph) have higher error rates. The lines are the limits until the auto jitter buffer algorithm changes its size.