From: Erwin M. [G. Net.Solutions] <e.m...@ge...> - 2002-07-12 07:44:18
|
ke...@ce... wrote: > ______________________________________________________________ >=20 >>Od: Erwin Mascher <e.m...@ge...> >>Komu: lir...@li... >>CC:=20 >>Datum: Wed, 10 Jul 2002 23:00:29 +0200 >>P=F8edm=ECt: mandrake 8.2 crash :( >> >>Hi List! >> >>I'm quite new to lirc, and i hope this question has not been=20 >=20 > asked a 100=20 >=20 >>times at this list. >>(i searched through the archive quite a bit, but couldn't find=20 >=20 > it) >=20 >>On my 08/15 standard Mandrake 8.2 box the following happens: >> >>install lirc >>(tried with and without insmod lirc_serial) >>start lircd (with a config file created under winXP, which=20 >=20 > works with=20 >=20 >>winLIRC) >>start mode2 / irexec >>(box is running) >>press any key at the remote control >>box is crashed, and can just be resetted. >=20 >=20 > YOU HAVE TO COMPILE LIRC WITH GCC 2.96., NOT 3.0.X, IT DOESN'T=20 > WORK!!!!!!! ^^^^^^^^^^^^^^^^^^^^ > I have homebrew receiver from lirc site on COM1 and Mandrake 8.2.=20 > I did the following from lirc 0.6.5 source dir: >=20 > ./setup.sh (without changing any values) --> Save and configure > make && make install > chmod 666 /dev/lirc* > setserial /dev/ttyS0 uart none > modprobe lirc_serial > mode2 >=20 >=20 thanks a lot, this one works. should be mentioned somewhere in the faq (=20 or did i miss it?), that GCC >=3D 3 does not work regards, erwin |