Re: Problems with serial module compiled into kernel

[Karl B. <ka...@tu...>]

Hi Timo,

Your log shows lircd(pctv),
which is lircd compiled to run with a user mode serial device(Pinnacle 
Systems)
instead of the home-brew serial circuit(uses custom driver lirc_serial).

I suggest downloading the latest version lircd-0.6.5, and configure, compile
and install this from scratch.

Karl


Timo Toots wrote:

>Hello!
>
>I had lots of trouble compiling LIRC under Redhat 7.2, but finally i did
>it.
>
>I have this home-brew receiver they had tutorial for. So, mode2 showed
>the right thing when i pushed buttons on my remote control and lircd
>also worked until i ran a client. Then it crashed and the log said:
>
>Apr 24 03:48:10 drome lircd-0.6.4: lircd(pctv) ready
>Apr 24 04:09:03 drome lircd-0.6.4: accepted new client on /dev/lircd
>Apr 24 04:09:04 drome lircd-0.6.4: could not reset tty
>Apr 24 04:09:04 drome lircd-0.6.4: caught signal
>Apr 24 23:48:29 drome lircd-0.6.4: lircd(pctv) ready
>Apr 24 23:50:20 drome lircd-0.6.4: accepted new client on /dev/lircd
>Apr 24 23:50:20 drome lircd-0.6.4: could not reset tty
>Apr 24 23:50:20 drome lircd-0.6.4: caught signal
>Apr 24 23:50:27 drome lircd-0.6.4: lircd(pctv) ready
>
>I tried to free the ttyS0 port with "setserial /dev/ttyS0 uart none" as
>they suggested in the documentation, but still the same thing.
>
>So i would be most grateful for help.
>
>Timo
>(from Estonia)
>
>
>