From: Dan H. <dan...@gm...> - 2010-11-03 22:24:31
|
I recently upgraded my system to Fedora 14 from 13 using preupgrade. Everything seemed to be upgraded fine, but something with lirc got broken in the update. I currently have lirc 0.8.7 installed. I have a streamzap IR receiver paired with a URC-R6 universal remote control. This worked on F13 but no longer on F14. I see output when running mode2 and press buttons. But if I run "irw" I see no output. I tried using irrecord and it would fail once I got to the step where I could hold down a button. I am trying to use lirc for mythtv. I see mythtv connect to the lirc daemon when mythtv starts. Below is my lircd.conf # # this config file was automatically generated # using lirc-0.8.3(default) on Fri Jul 18 21:05:45 2008 # # contributed by Cigy Cyriac # # brand: Avex # model no. of remote control: URC-R6 # devices being controlled by this remote: DVR/VCR (001) # begin remote name Avex_URC-R6_PVR bits 16 flags SPACE_ENC|CONST_LENGTH eps 30 aeps 100 header 9018 4447 one 621 1622 zero 621 488 ptrail 621 repeat 9020 2203 pre_data_bits 16 pre_data 0xA10C gap 107663 toggle_bit_mask 0x0 begin codes power 0xF00F up 0x2807 down 0x6807 left 0xE807 right 0xA807 sel 0x9807 menu 0x4807 guide 0x6C03 info 0xC807 exit 0xA20D chup 0x7807 chdn 0xF807 a 0xE00F b 0x220D c 0x620D d 0xE40B skip- 0x1807 skip+ 0x5807 rew 0x440B play 0x840B ff 0x240B stop 0xA40B pause 0xC40B stop 0xA40B pause 0xC40B rec 0x040B 1 0x140B 2 0x940B 3 0x540B 4 0xD40B 5 0x340B 6 0xB40B 7 0x740B 8 0xF40B 9 0x0C03 10+ 0x4C03 0 0x8C03 enter 0xCC03 # Mapped to panasonic_vcr codes # input vcr-tv # last zero # pip play # swap stop # move rew # freeze ff end codes end remote Thanks for any help! Dan |