From: Rui F. <ru...@ru...> - 2008-09-09 22:03:08
|
Hi Does anyone have any suggestions on this issue? Thanks, -Rui On Sun, Sep 7, 2008 at 10:52 AM, Rui Fernandes <ru...@ru...> wrote: > Hi, > > I've had Ubuntu(8.04) running for a while on my laptop (Toshiba > satellite) and yesterday I tried hooking up a ADS-Tech usb IR Blaster > which is listed in the support hardware list for LIRC using the usbx > driver. Using dmesg I can see the device coming up on /dev/ttyUSB0. I > am not sure how I need to setup the hardware.conf file to make this > thing work. > I tried a few different combinations and now I can start the LIRC > daemon and it stays up and I can start irw without any problems. But > it does not provide any output. I tried mode2 and it tells me that it > cannot find the device. I tried the command sequence bellow and as you > can see the results are not any better. > >>$ ls -asl /dev/lirc* > 0 srw-rw-rw- 1 root root 0 2008-09-07 10:08 /dev/lircd >>$ sudo mode2 -d /dev/lircd > mode2: error opening /dev/lircd > mode2: No such device or address > > I pasted my hardware.conf below. Any suggestions? Any help would be > greatly appreciated. > -Rui > > # /etc/lirc/hardware.conf > # > #Chosen Remote Control > REMOTE="USB-UIRT" > REMOTE_MODULES="" > REMOTE_DRIVER="usbx" > REMOTE_DEVICE="" > REMOTE_LIRCD_CONF="" > REMOTE_LIRCD_ARGS="-d /dev/ttyUSB0" > > #Chosen IR Transmitter > TRANSMITTER="USB-UIRT2 : Direct TV Receiver" > TRANSMITTER_MODULES="" > TRANSMITTER_DRIVER="" > TRANSMITTER_DEVICE="" > TRANSMITTER_LIRCD_CONF="directtv/general.conf" > TRANSMITTER_LIRCD_ARGS="" > > DRIVER="usb_uirt_raw" > > #Enable lircd > START_LIRCD="true" > > #Don't start lircmd even if there seems to be a good config file > #START_LIRCMD="false" > > #Try to load appropriate kernel modules > LOAD_MODULES="false" > > # Default configuration files for your hardware if any > LIRCMD_CONF="" > > #Forcing noninteractive reconfiguration > #If lirc is to be reconfigured by an external application > #that doesn't have a debconf frontend available, the noninteractive > #frontend can be invoked and set to parse REMOTE and TRANSMITTER > #It will then populate all other variables without any user input > #If you would like to configure lirc via standard methods, be sure > #to leave this set to "false" > FORCE_NONINTERACTIVE_RECONFIGURATION="false" > START_LIRCMD="" > |