Re: MCE USB remove responsiveness

[Stephen R. <st...@ro...>]

Mine is very responsive (mceusb2). I have the same header settings as you.

I did have to adjust the repeat setting to get it to respond well, all 
my button presses in my lircrc file have repeat = 3

Hope this helps

Robin Murray wrote:
> I was wondering if there was a way to improve the responsiveness of my 
> MS MCE USB remote.
>
> Sometimes there's a delay of 3-5 seconds before it responds. If during 
> that time I get impatient and push the button again, then it will 
> execute an extra button press right after it finally processes the first 
> one. This can be extremely irritating at times. I would say that 70% of 
> the time it works just fine and responds as I would like.
>
> Are there any tweaks I can do to the config file I have for it that 
> would improve things?
>
> I'm using lirc 0.8.2 on kubuntu feisty.
>
>   name mceusb
>   bits           16
>   flags RC6|CONST_LENGTH
>   eps            30
>   aeps          100
>   header       2667   889
>   one           444   444
>   zero          444   444
>   pre_data_bits  21
>   pre_data       0x37FF0
>   gap            105000
>   toggle_bit     22
>   rc6_mask       0x100000000
>
> Thanks!!
>
> Robin Murray
>
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2005.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
>