Re: irrecord

[Josh <Two...@th...>]

Benjamin Watkins wrote:
> On 3/14/2007 12:06 PM, Josh wrote:
>   
>> I figured out how to irrecord in raw mode (simple enough, I should have 
>> RTFM before asking how-to) so I did that and still nothing. I have taken 
>> a couple of more troubleshooting steps. Since I already had a dtvrc16 IR 
>> output config in the lircd.conf file, I dug one of my D10-300's out of 
>> the closet and plugged it in near the IR transmitter... I sent it the 
>> Menu command "irsend SEND_START dtvrc16 Menu" and nothing happened, so I 
>> went over to the D10-300 and I held it REALLY close (< 1/4" / 2 cm) to 
>> the IR transmitter and it picked up the signal... so I have verified 
>> that transmissions will in fact work. I then send the command to "mute" 
>> my Denon and still nothing there... I guess it's progress since it works 
>> fine with one device just not another.
>>
>> Any ideas?? I'm going to tear the cover off the Denon Receiver and put 
>> the IR transmitter directly on the Denon's IR receiver so hopefully that 
>> will yield some better results.
>>     
>
> Is it possible that this remote control uses an odd carrier frequency?
> I know there has been some work recently on setting the carrier
> frequency on the MCE transmitter/receivers.
>
> There were some posts on March 9 that discuss this.  I can't provide a
> link because the archive doesn't have any of the March messages yet.
> John Ross started the thread.  I believe Daniel M is working on this.
>
> -Ben : )
>
>
>
> -------------------------------------------------------------------------
> Take Surveys. Earn Cash. Influence the Future of IT
> Join SourceForge.net's Techsay panel and you'll get the chance to share your
> opinions on IT & business topics through brief surveys-and earn cash
> http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV
>
>
>
>   

I would assume that anything is possible. Do you know of a way in which 
I could test this? Also, I have a OneForAll remote (URC-8011B00) that I 
can use to control the Denon receiver using 4 digit code 1160.

-- 
Josh