Re: irrecord

[Benjamin W. <ben...@co...>]

On 3/14/2007 12:06 PM, Josh wrote:
> I figured out how to irrecord in raw mode (simple enough, I should have 
> RTFM before asking how-to) so I did that and still nothing. I have taken 
> a couple of more troubleshooting steps. Since I already had a dtvrc16 IR 
> output config in the lircd.conf file, I dug one of my D10-300's out of 
> the closet and plugged it in near the IR transmitter... I sent it the 
> Menu command "irsend SEND_START dtvrc16 Menu" and nothing happened, so I 
> went over to the D10-300 and I held it REALLY close (< 1/4" / 2 cm) to 
> the IR transmitter and it picked up the signal... so I have verified 
> that transmissions will in fact work. I then send the command to "mute" 
> my Denon and still nothing there... I guess it's progress since it works 
> fine with one device just not another.
>
> Any ideas?? I'm going to tear the cover off the Denon Receiver and put 
> the IR transmitter directly on the Denon's IR receiver so hopefully that 
> will yield some better results.

Is it possible that this remote control uses an odd carrier frequency?
I know there has been some work recently on setting the carrier
frequency on the MCE transmitter/receivers.

There were some posts on March 9 that discuss this.  I can't provide a
link because the archive doesn't have any of the March messages yet.
John Ross started the thread.  I believe Daniel M is working on this.

-Ben : )