"value" instead of "code" is changing

[Tiemen G. <ti...@gm...>]

Hi,

A while ago someone asked if it is possible to configure LIRC to use
the value rather than the code to recognise buttons, because this is
the output of irrecord:

-- first button press --
 irrecord: devinput_rec
 irrecord: time 1120506480.602489  type 2  code 10  value 247
 irrecord: code 8002000a
 irrecord: devinput_rec
 irrecord: time 1120506480.602493  type 2  code 11  value 3
 irrecord: code 8002000b
 irrecord: devinput_rec
 irrecord: time 1120506480.602497  type 2  code 12  value 252
 irrecord: code 8002000c
 irrecord: devinput_rec
 irrecord: time 1120506480.602501  type 0  code 0  value 0
 irrecord: code 00000000
 -- next button press --
 irrecord: devinput_rec
 irrecord: time 1120506483.361999  type 2  code 10  value 247
 irrecord: code 8002000a
 irrecord: devinput_rec
 irrecord: time 1120506483.362004  type 2  code 11  value 4
 irrecord: code 8002000b
 irrecord: devinput_rec
 irrecord: time 1120506483.362007  type 2  code 12  value 251
 irrecord: code 8002000c
 irrecord: devinput_rec
 irrecord: time 1120506483.362011  type 0  code 0  value 0
 irrecord: code 00000000

 The conf file created looks like this:

  bits            0
  eps            30
  aeps          100

  one             0     0
  zero            0     0
  pre_data_bits   32
  pre_data       0x8002000A
  gap          211804
  toggle_bit      32


      begin codes
          POWER                    0x0000000000000000
          UP                       0x0000000000000000
          BACK                     0x0000000000000000
          LEFT                     0x0000000000000000
          OK                       0x0000000000000000
          RIGHT                    0x0000000000000000
          PRE                      0x0000000000000000
          DOWN                     0x0000000000000000
          NEXT                     0x0000000000000000
          STOP                     0x0000000000000000
          PLAY                     0x0000000000000000
          VOL+                     0x0000000000000000
          MENU                     0x0000000000000000
          VOL-                     0x0000000000000000
      end codes

I recently bought the same remote (Edio USB remote, which seems to
work as a HID USB device) and I was wondering if there's a solution.

Thanks in advance,
Tiemen