Re: [ivtv-devel] hauppauge pvr-150 ir blaster patch - updated

[Gregory J. H. <ha...@on...>]

Mark,

I am sincerely grateful for your work on this, and I just can't wait to=20
do some testing for you. Unfortunately, I'm in the middle of a ton of=20
work right now and I just can't get a good couple of hours free to work=20
with it. It may be a month or so before I can get to it, but I=20
definitely will, and I'll post the results.

Thanks again,

Greg Haase

Mark Weaver wrote:

> Changelog (from http://www.blushingpenguin.com/mark/blog/?p=3D18):
>
> - Use schedule_timeout not mdelay as mdelay is a busy loop. This fixes=20
> high CPU usage during IR sending.
> - Drop out of the polling loop when the chip is ready rather than=20
> after 1s (can=92t believe I didn=92t notice this one!). This greatly=20
> speeds sending.  Fiddle with gap parameter in lircd.conf to avoid=20
> confusing the device you are controlling (for reference, it's in=20
> microseconds and I use 1/3s ~ gap 333333).
>
> Original HOWTO at http://www.blushingpenguin.com/mark/blog/?p=3D17
>
> This has been working well for me for nearly two weeks, although=20
> no-one else has had any luck!  Testing feedback welcome.
>
> Thanks,
>
> Mark
>
>
> -------------------------------------------------------
> SF.Net email is Sponsored by the Better Software Conference & EXPO
> September 19-22, 2005 * San Francisco, CA * Development Lifecycle=20
> Practices
> Agile & Plan-Driven Development * Managing Projects & Teams * Testing=20
> & QA
> Security * Process Improvement & Measurement * http://www.sqe.com/bsce5=
sf
> _______________________________________________
> ivtv-devel mailing list
> ivt...@li...
> https://lists.sourceforge.net/lists/listinfo/ivtv-devel