Re: [Linux-gpib-general] I need some help debugging an ECIC problem with my card

[David G. <dav...@po...>]

I unplugged the cable at the controller at the test program completes, 
therefore one of my 8 cables must be bad.  I have a lot of gear on that 
one card.

It was the last cable or the HP 6038A PSU in the chain, sorry to have 
spammed the list so much

davygrvy@workbench:~$ ./tibrsc
Initilisation        ibsta 0x1120 lines 0x30ff ibsta 0x1120
Set no ren           ibsta 0x1120 lines 0x20ff ibsta 0x1120
Release control      ibsta 0x1120 lines 0x20ff ibsta 0x1120
Request control      ibsta 0x1120 lines 0x30ff ibsta 0x1120
Send interface clear ibsta 0x1120 lines 0x30ff ibsta 0x1120
Assert ATN           ibsta 0x1130 lines 0x72ff ibsta 0x1130
Go to standby        ibsta 0x1120 lines 0x30ff ibsta 0x1120
Release control      ibsta 0x1120 lines 0x20ff ibsta 0x1120
Request control      ibsta 0x1120 lines 0x30ff ibsta 0x1120
davygrvy@workbench:~$ ibterm -m 0 -d 25
Attempting to open /dev/gpib0
pad = 25, sad = 0, timeout = 10, send_eoi = 1, eos_mode = 0x0000
ibterm>ID?
ID TEK/SG5010,V81.1,F1.1;
ibterm>