Re: [Linux-fbdev-users] Usage of mmap command

[Denis O. K. <do...@di...>]

kaka wrote:
> Hi Denis,
> 
> Thanks for the reply.
> I am writing gfxdriver for directFB library for broadcom chip.
> I have also written a frambuffer driver for broadcom chip.

Directly for broadcom or at another company?

> In directFB code,
> 
> static volatile void *
> system_map_mmio( unsigned int    offset,
>                  int             length )
> {
>      void *addr;
> 
>      if (length <= 0)
>           length = dfb_fbdev->shared->fix.mmio_len;
> 
>      addr = mmap( NULL, length, PROT_READ | PROT_WRITE, MAP_SHARED,
>                   dfb_fbdev->fd, dfb_fbdev->shared->fix.smem_len + offset );
>      if ((int)(addr) == -1) {
>           D_PERROR( "DirectFB/FBDev: Could not mmap MMIO region "
>                      "(offset %d, length %d)!\n", offset, length );
>           return NULL;
>      }
> 
>      return(volatile void*) ((u8*) addr + (dfb_fbdev->shared->fix.mmio_start&
>                                            dfb_fbdev->shared->page_mask));
> }

Can you add printfs to show dfb_fbdev->shared->fix.mmio_start, mmio_len,
smem_start and smem_len?

> the length and offset i am providing as 0 and -1.

You mean offset 0 and length -1?

> It is throwing me error as Could not mmap MMIO region.
> length coming from dfb_fbdev->shared->fix.smem_len is 16,00,000.

1600000 = 1.6MB?

> When i change the code to  addr = mmap( NULL, 900000, PROT_READ |
> PROT_WRITE, MAP_SHARED, dfb_fbdev->fd, dfb_fbdev->shared->fix.smem_len +
> offset );

You changed the length to 900000, but you need to use this to map offset
900000:

addr = mmap( NULL, length, PROT_READ | PROT_WRITE, MAP_SHARED,
dfb_fbdev->fd, 900000 );

But it should work if you set smem_len to 900000 in the fb driver.

> Then it works fine but it is not allowing me to write to addresses with
> offset greater than 900000.

Segfault?

> My requirement is to write in to the MMIO registers with offset between
> 900000 and 16 00 000.

What exactly is your frame buffer size and physical MMIO address?

You need to put the frame buffer size into smem_len and the physical
MMIO address into mmio_start, the length into mmio_len.

-- 
Best regards,
  Denis Oliver Kropp

.------------------------------------------.
| DirectFB - Hardware accelerated graphics |
| http://www.directfb.org/                 |
"------------------------------------------"