Re: [Linux-fbdev-devel] Mobility M1 refresh code problem 2.4.26?

[Richard S. <rs...@bi...>]

Mikael Eriksson wrote:

> dmesg:
> atyfb: using auxiliary register aperture
> atyfb: Mach64 BIOS is located at c0000, mapped at c00c0000.
> atyfb: BIOS contains driver information table.
> atyfb: colour active matrix monitor detected: Samsung LT141X4-156
>         id=2, 1024x768 pixels, 262144 colours (LT mode)
>         supports 60 Hz refresh rates, default 60 Hz
>         LCD CRTC parameters: 15384 167 127 130 0 17 805 767 769 6
> atyfb: 3D RAGE Mobility (PCI) [0x4c4d rev 0x64] 8M SDRAM, 29.498928 MHz 
> XTAL, 230 MHz PLL, 83 Mhz MCLK, 125 Mhz XCLK
> 
> .config:
> CONFIG_FB_ATY=y
> # CONFIG_FB_ATY_GX is not set
> CONFIG_FB_ATY_CT=y
> CONFIG_FB_ATY_GENERIC_LCD=y
> # CONFIG_FB_ATY128 is not set
> 
> boot-param:
> video=atyfb:1024x768-32

Hmmm... I had GX set.  Unsetting and rebuilding did change things.  the 
text is almost readable but its still not quite right.

I was doing it as a module rather than at boot time but changing to the 
driver compiled in still has the same result.

My dmesg output is identical to yours.  But X still logs a differnt 
refresh rate code of 7.  What refresh rate code is in your X windows log 
file?

I'm doing a make clean;make bzImage right not to be sure its not some 
holdover of haveing GX enabled on my original build.