Re: XFConfig file

[J. <kh...@te...>]

Hello Andreas

On 01-Nov-02, you wrote:

> Hello Bj=F6rn
>=20
> Am 01-Nov-02 schrieb Bj=F6rn Johansson:
>=20
>> Hello Michel
>>=20
>> On 01-Nov-02, you wrote:
>>=20
>>> On Fre, 2002-11-01 at 07:48, Bj=F6rn Johansson wrote:
>>>=20
>>>> (II) S3VIRGE: driver (version 1.6.13) for S3 ViRGE chipsets: virge,
>>>> 86C325,
>>>>     virge vx, 86C988, virge dx, virge gx, 86C375, 86C385, virge gx2,
>>>>     86C357, virge mx, 86C260, virge mx+, 86C280, trio 3d, 86C365,
>>>>     trio 3d/2x, 86C362, 86C368
>>>>     S3VProbe begin
>>>> (EE) No devices detected.
>=20
> Using S3 Virge with a Permedia II based card? I'm a bit puzzled.. Shoul=
d
> this really work??
>=20
>>>> Fatal server error:
>>>> no screens found
>>>=20
>>> Why are you trying to use the s3virge driver, when all the sample
>>> XF86Config files say glint?
>>>=20
>>=20
>> I thought that maybe the CybervisionPPC had support for this,
>> but I guess it hasn't. Anyway, glint doesn't work either.
>> Could it be that I've missed a package when I installed the
>> X-server, perhaps?
>=20
> Why does glint not work? Are you getting any error messages? But, anywa=
y,
> it is known that glint doesn't work flawlessly with the CybervisionPPC.
> Use following setup
>=20
> Section "Device"
>    Identifier    "Generic Video Card"
>    Driver        "fbdev"
>    Option        "NoInt10"
> EndSection
>=20
> If it then finds a device but still doesn't start up, you have to creat=
e
> your own mode lines using fbset. For a 17" monitor it could look like t=
his
>=20
> Section "Monitor"
>    Identifier    "Generic Monitor"
>    HorizSync    30-65
>    VertRefresh    50-90
>    Option        "DPMS"
>=20
>    Mode "1024x768"
>        # D: 78.933 MHz, H: 60.162 kHz, V: 75.203 Hz
>        DotClock 78.934
>        HTimings 1024 1040 1136 1312
>        VTimings 768 769 772 800
>        Flags    "+HSync" "+VSync"
>    EndMode
> EndSection
>=20
> You may compare you're current XF86Config with the attached XF86Config
> which should work for a CybervisionPPC (at least it worked on my machin=
e,
> and still works..).
>=20
> But you don't need most of the "Module" mumbo-jumbo, so go and comment =
it
> out (well, not everything of course, you have to consult some kind of
> documentation..).
>=20
>=20

Hi again!

I've tried your XF86Config file and it still gives me problems.
I have attached the latest log file to this mail, please have a
look at it.

--=20
Kind regards  Bj=F6rn Johansson

http://w1.173.telia.com/~u17308024