Re: Compiling problems with 2.4

[Michel <mic...@ii...>]

Ren=E9 Thol wrote:

> > If you have run make dep after checking out or updating the source th=
en it
> > means that the dependencies don't work as they should.
>=20
> And how do I get them work (I tried compiling with and without make dep
> clean before starting make)

Fix the code. ;) Anyway, I'm not sure anymore that's the problem...


> > > And how do I compile a 2.4 kernel that can use my printer on the
> > > parallel port?
> >
> > In 'General setup', select 'Parallel port setup' and then 'Amiga buil=
tin
> > port'. Your mileage will vary - It doesn't work for Frank while Rober=
t
> > says it kinda works for him.
>=20
> As I said: I already tried, but could not compile! Now I can not even
> compile my already compiled config!

Weird. I just tried your config, built fine. Then I enabled parallel port
support and it built. I disabled it again and it still built.

When did you last update your source? Looks like it was before 2.4.1.

What gcc and binutils do you have? (gcc -v and ld -v)


--=20
Earthling Michel D=E4nzer (MrCooper)    \   Debian GNU/Linux (powerpc) de=
veloper
CS student, Free Software enthusiast   \        XFree86 and DRI project m=
ember