Re: 2.2.10, SCSI driver and parranel port driver

[Michel <dae...@st...>]

Marek Szyprowski wrote:

> In current version there is a problem with build-in parranel port support.
> Athough the driver works, it dosn't work correctly. Problems apprears when I
> try to print some gfx - I get garbage, but not picture. (printing of ANSI
> texts works).

You're lucky, I never managed to print anything but garbage with the new
driver.


> After looking in source I noticed, that kernel uses "parport",
> "parport_amiga" and "lp" driver for build-in parranel port (and printer)
> support. In older kernel version another drivers ("lp_m68k" and
> "lp_intern") were used for parranel port.


> How could I enable "lp_m68k" driver compilation?

Enable parallel printer support near the bottom of the General Setup as a
module.


> I think that finding correct values for timeout once again won't take me
> much time.

Please supply a patch when you have fixed it!


> My second question is about scsi driver for BlizzPCC+. Why, always when I
> use any tool for playing music CD i got a message from kelnel like this
> one:
> scsi0 : datain+dataout for command 0x42 02 40 01 00 00 00 00 10 00
> scsi0 : datain+dataout for command 0x42 02 40 01 00 00 00 00 10 00
> scsi0 : datain+dataout for command 0x47 00 00 00 02 00 49 00 4a 00
> 53c7xx: Non-aligned buffer with datain && dataout
> 
> (repeated many, many times).
> 
> How could I disable this? (its vey anoying...)

But it works? Have you enabled SCSI logging or similar?


Michel


-- 
Earthling Michel Dänzer (MrCooper)  \  CS student and free software enthusiast
Debian GNU/Linux (powerpc,i386) user \   member of XFree86 and The DRI Project