Trying to messure the angle between two segments of a polyline, the command does not seam to detect the polyline segments as valid enteties for selection.
Verification of fix failed. To reproduse failure open the attached angle.dxf and as the first edge to select use the bottom horisontal line. For some reason this and some other lines are not possible to select as first line.
This should maybe be a new bug? since poliline angle messuring now seams to work
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Patched in master branch commit 37d2d1f337
Please, test it if the patch is correct close this bug report
Verification of fix failed. To reproduse failure open the attached angle.dxf and as the first edge to select use the bottom horisontal line. For some reason this and some other lines are not possible to select as first line.
This should maybe be a new bug? since poliline angle messuring now seams to work
Test file
New patch in master branch commit c74f6d03a2
Please, re-test it, if the patch is correct close this bug report
Works like a charm