You write that from version 0.8 it is possible to access the PLC with CP5511, could you please write a short describtion on how to setup this connection from Excel.
Thanks
Christian
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Thomas has included an example for Excel with libnodave in the subdirectory "Excel and VB".
To use the CP551 you must change some lines in the sub "initialize" as described there in the comments.
A CP5511 is used via communication dlls and drivers from Siemens, thus it is neccessary to setup a connection with "Set PG/PC interface" in the Control Panel.
Axel
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
You write that from version 0.8 it is possible to access the PLC with CP5511, could you please write a short describtion on how to setup this connection from Excel.
Thanks
Christian
Thomas has included an example for Excel with libnodave in the subdirectory "Excel and VB".
To use the CP551 you must change some lines in the sub "initialize" as described there in the comments.
A CP5511 is used via communication dlls and drivers from Siemens, thus it is neccessary to setup a connection with "Set PG/PC interface" in the Control Panel.
Axel
Libnodave doesn't work using s7onlinx.dll
version 603.201.103.3. I can using the connection
function,but not the read/write functions.
I used:
-cp5611
-step7 ver. 5.3