Re: [leaf-user] Bering can't handle Dell GX150 integrated Ethernet?

[Henning J. <me...@gm...>]

> With Bering, using the 3c59x.o module found via the Bering installation
> guide, neither interface is brought up.

Did you try to append a boot-Parameter like
ether=0,0,eth0 ether=0,0,eth1

The exact syntax for ether= may be found in the ethernet-howto:
---- snip
 There are two ways that you can enable auto-probing for the second
  (and third, and...) card. The easiest method is to pass boot-time
  arguments to the kernel, which is usually done by LILO. Probing for
  the second card can be achieved by using a boot-time argument as
  simple as ether=0,0,eth1. In this case eth0 and eth1 will be assigned
  in the order that the cards are found at boot.  Say if you want the
  card at 0x300 to be eth0 and the card at 0x280 to be eth1 then you
  could use
       LILO: linux ether=5,0x300,eth0 ether=15,0x280,eth1
---- snip


good luck