[lcd4linux] Couldn't start parallel port

[Daniele <mal...@ya...>]

Hi..I'm new here.  I hope you can help me..
I've got last lcd4linux running on my 2.6.21 - Archlinux and a 20x4 HD44780 
display. My config file work fine, i think, because on other pc it works with 
that display. On my first pc, I haven't the parallel port, so i bought a pci 
parallel controller. This is lspci output:
>01:07.0 Parallel controller: Timedia Technology Co Ltd Unknown device 7268 
(rev 01)

this is the output of dmesg when i wrote #modprobe parport_pc
>PCI parallel port detected: 1409:7268, I/O at 0xac00(0xa800)
>parport0: PC-style at 0xac00 [PCSPP,TRISTATE,EPP] 

and the output of #modprobe lp
>lp0: using parport0 (polling).

In the config file the device is /dev/lp0. if I run 
#lcd4linux -F -f /etc/lcd4linux.conf -v -q i've got:

>Version 0.10.1-RC1-768 starting
>[KVV] Using station 89
>[KVV] Using default port 80
>[KVV] Using default refresh interval of 60 seconds
>[KVV] Default abbreviation setting: off
>HD44780: $Rev: 741 $
>HD44780: using model 'generic'
>HD44780: using parallel port
>HD44780: using 1 Controller(s)
>HD44780: using 8 bit mode
>udelay: The file 'include/asm/msr.h' was missing at compile time.
>udelay: Even if your CPU supports TSC, it will not be used!
>udelay: You *really* should install msr.h and recompile LCD4linux!
>udelay: using gettimeofday() delay loop
>HD44780: using ppdev /dev/lp0
>HD44780: ioctl(/dev/lp0, PPCLAIM) failed: 22 Invalid argument
>HD44780: could not initialize parallel port!
>HD44780: start display failed!

What the hell.. i can't use my lcd!

I hope again that anyone can help me..
Chiacchiera con i tuoi amici in tempo reale! 
 http://it.yahoo.com/mail_it/foot/*http://it.messenger.yahoo.com