SPLINE entities have gap

Brought to you by: simijhag

#6 SPLINE entities have gap

Status: open

Owner: Simon Mieth

Labels: None

Priority: 5

Updated: 2009-07-08

Created: 2009-07-07

Creator: Simon Arthur

Private: No

The Kabeja UI shows a small gap on the right hand side of the diagram, near the top where the round "cap" meets the straight side. Neither QCad and SolidEdge show this gap; they both show a closed curve.

Discussion

Simon Arthur - 2009-07-07

K7R8-U6A2-test2-mod.dxf

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Simon Arthur - 2009-07-07

Screen Capture in QCad on linux.

screencap-kabeja-qcad-screen1.png

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Simon Arthur - 2009-07-07

Screen capture in Kabeja 0.4, showing the gap on the right hand side.

screencap-kabeja-ui-screen2.png

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Simon Arthur - 2009-07-07

Screen capture in SolidEdge on Windows.

screencap-solidEdge-kabeja.png

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Simon Mieth - 2009-07-08

assigned_to: nobody --> simijhag
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

SPLINE entities have gap

Group

Searches

Help

#6 SPLINE entities have gap

Discussion