I have installed and completed all steps required for monitoring the application.I tried to start a session from Jensor workspace ,but it says "There is no Jensor Running"
Inthis case what are config should be checked and where can be the problem.
Thanks
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I suppose that you did the instrumentation process and then replaced the original files with the instrumented ones.
After doing this, the application and specifically the instrumented classes should be invoked in order for the Jensor Server to be running within the instrumented code. Only then will you be able to collate the logs.
Also if after doing this the same message is getting replayed then, go ahead and see the Application logs and send them over so that they could be referred for understanding the problem.
Regards,
Suresh
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have installed and completed all steps required for monitoring the application.I tried to start a session from Jensor workspace ,but it says "There is no Jensor Running"
Inthis case what are config should be checked and where can be the problem.
Thanks
Hi Karthik,
I suppose that you did the instrumentation process and then replaced the original files with the instrumented ones.
After doing this, the application and specifically the instrumented classes should be invoked in order for the Jensor Server to be running within the instrumented code. Only then will you be able to collate the logs.
Also if after doing this the same message is getting replayed then, go ahead and see the Application logs and send them over so that they could be referred for understanding the problem.
Regards,
Suresh