Been using this for a while now (V 9.43 i think) on a Pi. It has been working great.
however after a recent rebuild I set the spin-down time & power saving factor the same as before
-B 127 & -S 24
now if i execute a manual spindown (-y) the next time the drive is accessed it doesn't spin back up again. It did before?
i'm going to try & remove current ver & go back to 9.43 to confirm.
Anyone any ideas in the mean time?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Been using this for a while now (V 9.43 i think) on a Pi. It has been working great.
however after a recent rebuild I set the spin-down time & power saving factor the same as before
-B 127 & -S 24
now if i execute a manual spindown (-y) the next time the drive is accessed it doesn't spin back up again. It did before?
i'm going to try & remove current ver & go back to 9.43 to confirm.
Anyone any ideas in the mean time?