[Gumstix-users] Read Only Overo Serial Port Connection

[Michael L. <mli...@us...>]

Alright...

I've successfully built and installed a new u-boot, uImage (kernel), and
rootfs on an SD card from the master branch.  When I put it in my Overo Fire
FE it boots with no errors (great!).  Unfortunately, I cannot control it via
the Tobi USB serial connection.  I've connected to it via both Putty and
kermit with these settings:

flow-control none
set carrier-watch off 
set speed 115200

I can read everything it puts out as it starts, but I can't login.  Here's
the last thing I see:

...
Yocto (Built by Poky 7.0.1) 1.2.1 
 ttyO2

overo login: Started Network Manager                                               
[  OK  ]
Starting Network Time Service...                                               
Started Network Time Service                                           [  OK 
]
Starting Notify Audit System and Update UTMP about System Runlevel
Changes...  
[   28.948608] smsc911x smsc911x.0: eth0: SMSC911x/921x identified at
0xe0816000, IRQ: 272
[   29.091064] libertas_sdio: Libertas SDIO driver
[   29.095855] libertas_sdio: Copyright Pierre Ossman
[   29.307861] IPv6: eth0: IPv6 duplicate address fe80::215:c9ff:fe28:e92a
detected!
[   30.847778] libertas_sdio mmc1:0001:1: (unregistered net_device):
00:19:88:15:be:30, fw 9.70.3p36, cap 0x00000303
[   30.870361] libertas_sdio mmc1:0001:1: wlan0: Marvell WLAN 802.11 adapter
[   36.320129] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready

Any ideas?



--
View this message in context: http://gumstix.8.n6.nabble.com/Read-Only-Overo-Serial-Port-Connection-tp4966146.html
Sent from the Gumstix mailing list archive at Nabble.com.