From: Alex G. <al...@al...> - 2011-05-11 00:38:26
|
On 11/05/2011 3:16 AM, Anthony Nwokafor wrote: > Hi, Just got an Overo Tide and a Tobi board to use in an SDR project. I can't seem to find any directions on how to set up a development envrionment? Specifically I have code that needs to go on the DSP in the OMAP processor. > > Can anyone provide links? > > Thanks in advance! gumstix.org for building the linux images then TI/omap wiki for the dsp side of things http://processors.wiki.ti.com/index.php/Getting_Started_With_C6Run_On_Beagleboard http://processors.wiki.ti.com/index.php/Category:DSPEaseOfUse elinux.org for other bits and pieces - just make sure to convert the beagle board stuff (especially io's) before using it http://elinux.org/BeagleBoard plus Scott Ellis very handy site http://www.jumpnowtek.com/ I'd suggest get familiar with building custom linux images first then add the c6run and load your dsp code/binaries Alex -- UTS CRICOS Provider Code: 00099F DISCLAIMER: This email message and any accompanying attachments may contain confidential information. If you are not the intended recipient, do not read, use, disseminate, distribute or copy this message or attachments. If you have received this message in error, please notify the sender immediately and delete this message. Any views expressed in this message are those of the individual sender, except where the sender expressly, and with authority, states them to be the views the University of Technology, Sydney. Before opening any attachments, please check them for viruses and defects. |