From: Søren S. C. <li...@ss...> - 2010-06-01 21:34:50
|
Hi Dave and Wenhua, > > I want to verify the way how to support 18 bit display from Overo > > Can i just connect each R/G/B (7:2) from Overo to R/G/B(5:0) on the > > LCD, leave the low 2 bits disconnected? > > I wouldn't recommend disconnecting them. They should be connected to > something (ground, Vcc, or another signal). > > I would connect the low 3 together. I think Wenhuas question is the other way around. The Overo is having a 24-bit LCD output and the LCD a 18-bit interface. In this case the correct approach would be to connect it as described by Wenhua and just letting the unused pins on the Overo float (or use them for something else - i.e. GPIO's in case wanted?). And in this case I'm sure you agree that it doesn't make sense to fix the unused pins together - nor to GND/VCC :-) Best regards Søren --- SSC Solutions ApS - Denmark - www.ssc-solutions.dk |