From: Heilpern, M. <mar...@au...> - 2009-07-10 19:52:46
|
I've received my Overo/Summit boards, and was successful getting the pair to boot over NAND. I also built my own image using the full OpenEmbedded system described in the wiki, and I've been successful in formatting an MMC to make it bootable, and all is going well (and though a very long process, was fairly painless). Now I'm ready to start me work ;) I need to make my own configuration changes (or at least verifications), and I need to build my own driver linked against my kernel. When I search the overo-oe directory after having built my full system, there seem to be several candidates for where the kernel source is located. Is there a particular place within the tree that I want to work from (both to "make config" to reconfigure my kernel, and to set as KDIR in my module, located external to this tree)? NOTE: The information in this message is intended for the personal and confidential use of the designated recipient(s) named above. To the extent the recipient(s) is/are bound by a non-disclosure agreement, or other agreement that contains an obligation of confidentiality, with AuthenTec, then this message and/or any attachments shall be considered confidential information and subject to the confidentiality terms of that agreement. If the reader of this message is not the intended recipient named above, you are notified that you have received this document in error, and any review, dissemination, distribution or copying of this message is strictly prohibited. If you have received this document in error, please delete the original message and notify the sender immediately. Thank You! AuthenTec, Inc. http://www.authentec.com |