From: Hugo V. <hug...@gm...> - 2009-05-05 02:51:51
|
Hi Steve, Depending on what kernel you're running, you can check the core temperature by doing: $ cat /sys/devices/platform/omap34xx_temp/temp1_input which will return the temperature in degrees Celcius. Out-of-the-box, I found my two Earths could get up to around 67 deg C under heavy load. With some kernel config changes (esp CONFIG_OMAP_RESET_CLOCKS), I was able to get that down to about 56. Thats with just still room-temperature air for cooling. It definitely runs hotter than I'd like, but doesn't seem to be anywhere near out of spec (IIRC max continuous for the processor is 85 deg C). Hugo On Tue, May 5, 2009 at 12:51 PM, Steve Reed <st...@sj...> wrote: > I'm just wondering if anyone has run into a heat issue or is even worried > about heat with the Overos. I got my Fire in on friday and it's great but > it seems pretty darn hot after running a few minutes. Maybe it's within > spec and it's ok, but I'm just wondering if leaving this running 24/7 would > be a problem? I don't see any info about heat-spreaders for the overo line > so I can only assume it's not a problem. > > > > ------------------------------------------------------------------------------ > The NEW KODAK i700 Series Scanners deliver under ANY circumstances! Your > production scanning environment may not be a perfect world - but thanks to > Kodak, there's a perfect scanner to get the job done! With the NEW KODAK > i700 > Series Scanner you'll get full speed at 300 dpi even with all image > processing features enabled. http://p.sf.net/sfu/kodak-com > _______________________________________________ > gumstix-users mailing list > gum...@li... > https://lists.sourceforge.net/lists/listinfo/gumstix-users > > |