From: Demetris Z. <fgc...@cy...> - 2009-02-11 13:14:53
|
Q: I remember the Verdex having 80x20. I'll have to meassure but I think your board may be too wide for my airframe. A: Please measure, these are prototypes and we used them on an RC helicopter rather than a plane. Q: Also I already have the GPSstix and the netWifiMicroSD-EU connected to have networking and GPS. Can your server&sensor-board replace any of these to free up the apropriate slot? A: Wait for the official release (on Friday afternoon) to get your questions answered. Also look on our Teaser Schematic to get a better understanding on how everything is connected. Q: You forgot to mention height and weight. A: Every PCB is not higher than 0.5cm, about the weight I'll have to check since we never actually weighted it :) Q: Do you supply kernel-modules for the ADC-channels on your sensor-board? What sensors and free adc-channels are there? A: The sensor board outputs SERIAL data for all of it's sensors. So no need for modules. Q: Also the Gumstix-Board does not have al the power-supplies. You have to feed it regulated 5V whereas your n-cell LiPo requires an active power-regulator to provide that (passive would be a bad idea here). A: The UAV MAIN PCB For Gumstix has all the nessesary power regulations. You can feed it up to 24V |