From: pvm <pvm...@gm...> - 2008-03-31 02:54:09
|
I don't know about the other signals but, as I understand it (and as it is described in section 20.3) the USB signal, USBH_PEN1 is an output that is supposed to control power to the USB device. I have to pull USBH_PWR1 low in order to enable the USB port on the 24pin connector. There is a diagram on the wiki that says to pull it high according to the manual it is configurable so depending on what version of the build root you are using I know there are people on this list that have done it both ways. -- View this message in context: http://www.nabble.com/24pin-connector-%28verdex%29-questions%3A-USBH_PEN1%2C-USBH_PWR1%2C-SYS_EN%2C-CLK_32-tp16343219p16391034.html Sent from the Gumstix mailing list archive at Nabble.com. |