Re: [Gumstix-users] GPIO17 output set low 10 minutes after power-on

[Chris D. <chr...@gm...>]

Yes, I'm not sure if its relevant since you're running a stock setup,
and I'm not sure how you could check to see if it was the case.  Sorry
I can't be of more help there - I just figured checking out the lcd
backlight stuff would be a good place to start :)

Mabye someone else has some ideas?

Chris

On Feb 13, 2008 3:03 PM, Jon Bosley <jo...@pr...> wrote:
>
> I haven't replaced the buildroot on these gumstix.  I set up the buildroot on
> my computer prior to the date of the buildroot on these gumstix, and haven't
> changed it since.  I am not very familiar with configuring the kernel.  When
> I run "make menuconfig" in my
> gumstix-buildroot/build_arm_nofpu/linux-2.6.21gum directory, under Device
> Drivers, Graphics support, there is an option for "Backlight and LCD device
> support", which is not selected.  However, I don't know how much that means
> since the gumstix don't have that buildroot on them.
>
>
>
> Chris Dollar wrote:
> >
> > Looking at the defconfig for verdex it seems that support for the
> > samsung is built into the kernel.  Mabye that change happened between
> > the 2 revisions that work/don't.  Can you check your kernel config
> > just to be sure?
> >
> > Chris
> >
>
> --
> View this message in context: http://www.nabble.com/GPIO17-output-set-low-10-minutes-after-power-on-tp15446665p15469070.html
>
> Sent from the Gumstix mailing list archive at Nabble.com.
>
>
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2008.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> _______________________________________________
> gumstix-users mailing list
> gum...@li...
> https://lists.sourceforge.net/lists/listinfo/gumstix-users
>