Re: [Gumstix-users] new verdex XM4-bt not reacting

[Steve S. <sa...@gm...>]

Marcus,

I think that bluetooth is broken in the buildroot version that is
shipping right now.  Sadly that means that you will need that console
board in order to reflash your motherboard.

Steve

On Feb 3, 2008 1:11 AM, Marcus Wolschon <Ma...@wo...> wrote:
> 2008/2/3, Dave Hylands <dhy...@gm...>:
> > Hi Marcus,
>
> Hi Dave.
>
> > > The labeled GND and VCC -pads for stuat,
> > > ffuart and NSSP on the backside of the
> > > gpsstix do not read any voltage, the power-
> > > adapter gives proper 5.x volt.
> >
> > That doesn't seem right.
> >
> > The Vcc signal on these pads comes from a voltage regulator on the
> > gpsstix board. You should be able to measure voltage on those pins,
> > even if the gumstix isn't plugged into the gpsstix board.
>
> The led on the gpsstik is glowing with and without a verdex.
> Maybe it's just this borrowed autorange-multimeter-withTooMayFeatures
> that is at fault here. I'll check that with my own tools tomorow.
>
> With the netwifi-board powering the verdex and no gpsstix
> the LED D2 is glowing but no D1.
> Is there some documentation what these LED are showing?
>
> I hope to have access to a console-board sometime this
> week. Let's hope it's something simple.
>
> Marcus
>
>
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2008.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> _______________________________________________
> gumstix-users mailing list
> gum...@li...
> https://lists.sourceforge.net/lists/listinfo/gumstix-users
>