From: Rodrigo S. <rod...@gm...> - 2006-11-30 22:03:27
|
Hi Toby, I use the following scheme: gumstix <----(hirose)---->gpsstix<--------(i2c)--------->robostix i mean, i use the breakout of the gpsstix of the signals from the gumstix, and connected SDA, SCL and GND properly... (not connected the VCC because the different voltages involved) soldered 3 cables on the gpsstix back. cheers Rodrigo On 11/30/06, Dave Hylands <dhy...@gm...> wrote: > > Hi Toby, > > On 11/30/06, Apps, T. x72430 B3 <Tob...@us...> wrote: > > Is it possible to connect a robostix and a GPSstix to a single > > motherboard? It looks like both are 60-pin and there are no > > motherboards with multiple 60-pin connectors. Thanks in advance. > > Not at the same time. You can however, plug the gpsstix into the > gumstix and connect up the robostix via the i2c bus. > > You'll need to worry about voltage conversion. There is a 3.3v to 5v > voltage conversion chip for i2c already on the robostix which you can > make use of (requires soldering some wires to the chip) or you can > something external. > > -- > Dave Hylands > Vancouver, BC, Canada > http://www.DaveHylands.com/ > > ------------------------------------------------------------------------- > Take Surveys. Earn Cash. Influence the Future of IT > Join SourceForge.net's Techsay panel and you'll get the chance to share > your > opinions on IT & business topics through brief surveys - and earn cash > http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV > _______________________________________________ > gumstix-users mailing list > gum...@li... > https://lists.sourceforge.net/lists/listinfo/gumstix-users > |