[Gumstix-users] Lexar CF problems

[Nelson R. Jr. <Nelson.Rosa.Jr@Dartmouth.EDU>]

I bought a Lexar Platinum 256 MB Compact Flash card and I'm having
trouble mounting it.  I followed the instructions on the website,
http://www.gumstix.org/tikiwiki/tiki-index.php?page=HOWTO%3A+Mount+Compact+Flash+Cards, but I'm not getting the /mnt/cf, but the /mnt/mmc folder is still there.  Also while the gumstix boots I get the cf card detected by hda and then hdb spits out an error message that it couldn't communicate with a device.  Here's what I get,

# Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 50MHz system bus speed for PIO modes; override with
idebus=xx
hda: LEXAR ATA FLASH, CFA DISK drive
hdb: no response (status = 0xa1), resetting drive
hdb: no response (status = 0xa1)
ide0 at 0xc4860000-0xc4860007,0xc486000e on irq 49
ide-cs: hda: Vcc = 5.0, Vpp = 0.0


Does anyone have any clues on what might be going on?  Could it be the
bus speed?