hi,
i found phenomena that i want to share with you:
as i told already my bus-system is not only in one private riser, i have ground floor = system1 and upper floor = system2. because of that i need to config the bticino number in grasshopper configuration for an actor in ground floor "32#4#01", for another actor in upper floor "32#4#02".
i also have several bmse1001 (movement detectors). they are configured to send cen-commands to be processed in mh200n.
following happens:
there is a light actor, bticino number 06#4#01 (a=0, pl=6, system=1). and there is a movement detector that is configured as cen 06.
always whenn the detector recognizes movement, the grasshopper software tells me light-actor would switch to "on" (it is not on, but software shows it would be)
if i monitor, the movement-detector notifys:
09.07.2015 08:27:13 172.20.90.2 MON RX Data received #106#4#01693##
and if i turn on/off the actor:
09.07.2015 08:39:17 172.20.90.2 MON RX Data received 1006#4#01##
09.07.2015 08:39:19 172.20.90.2 MON RX Data received 1106#4#01##
is this a problem only to me because of my special bticino-numbers or does anybody else have similar situations?
best regards, stefan
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
hi,
i found phenomena that i want to share with you:
as i told already my bus-system is not only in one private riser, i have ground floor = system1 and upper floor = system2. because of that i need to config the bticino number in grasshopper configuration for an actor in ground floor "32#4#01", for another actor in upper floor "32#4#02".
i also have several bmse1001 (movement detectors). they are configured to send cen-commands to be processed in mh200n.
following happens:
there is a light actor, bticino number 06#4#01 (a=0, pl=6, system=1). and there is a movement detector that is configured as cen 06.
always whenn the detector recognizes movement, the grasshopper software tells me light-actor would switch to "on" (it is not on, but software shows it would be)
if i monitor, the movement-detector notifys:
09.07.2015 08:27:13 172.20.90.2 MON RX Data received #106#4#01693##
and if i turn on/off the actor:
09.07.2015 08:39:17 172.20.90.2 MON RX Data received 1006#4#01##
09.07.2015 08:39:19 172.20.90.2 MON RX Data received 1106#4#01##
is this a problem only to me because of my special bticino-numbers or does anybody else have similar situations?
best regards, stefan