Re: [Gimp-print-devel] Support for EPSON R200

[Robert L K. <rl...@al...>]

   From: Robert L Krawitz <rl...@al...>
   CC: Gim...@li...
   Date: Sun, 30 May 2004 15:42:53 -0400

      From: Julien TIERNY <jul...@wa...>
      Date: Sun, 30 May 2004 18:47:23 +0200

	      I've just bought an EPSON R200 and I'm trying to make it work under 
      GNU/Linux.
	      Therefore, I've installed gimp-print-5.0 (pre-release 3) and remarked some of 
      you began to write a support for the R300 model.
	      I've performed some few tests with this support plugged-in to CUPS and 
      realize the support wasn't that advanced :-(
	      How could I help you as tester or developper ?

   What do you mean by "not very advanced"?  5.0-alpha3 should be fully
   tuned for that model.

That came out rather badly written, I'm afraid...

What problems are you seeing?

-- 
Robert Krawitz                                     <rl...@al...>

Tall Clubs International  --  http://www.tall.org/ or 1-888-IM-TALL-2
Member of the League for Programming Freedom -- mail lp...@uu...
Project lead for Gimp Print   --    http://gimp-print.sourceforge.net

"Linux doesn't dictate how I work, I dictate how Linux works."
--Eric Crampton