From: Tobias K. <t....@ca...> - 2008-07-09 05:17:03
|
Hi Michael, what a thorough test, thanks a lot! > Questions: > ========== > -"ManufactureDate (16 bits): 3824" > Is there a way to decode this to a human readable date? It's actually ManufactureDatA not ManufactureDatE :-) It's reserved for the Smartbattery-compliant manufacturer to put any data they like into this field. Don't know what Oceanserver uses it for, didn't find any hint in the docco. After three acceptance votes, I think I can move the driver into src now. Cheers, Tobi On Wed, 9 Jul 2008 02:54:12 pm Michael Moser wrote: > Hi guys, > > I've used a Oceanserver EK-05 battery controller & regulated DC kit to > test the gbxsmartbatteryacfr library. > > Worked out of the box, see below for details. > > Vote for acceptance. > > Cheers, > Michael > > ---------------------------------------------------------------------- > Setup: > ====== > Hardware: > EK-05 kit: > -BB-04FR Battery Managment Module (Firmware V2.10) > -DC123SR ATX Converter Module (DC/DC) > -PS100 AC/DC Power supply > -assorted cables > -2x BA-95HC-FL Li-ion batteries > > Software: > gbxsmartbatteryacfrtest, built as per example.readme. > > > Tests: > ====== > -Hooked up charger with out batteries: > reports 0 batteries, 4 ports with charge power. > > -Connected one battery to charger at different ports: > Battery detected and reported at correct port, different serial numbers > (consistent from run to run) reported for the batteries. > > -Connected both batteries at once to different ports: > Detected and reported correctly, consistent serial #. > > -Charged both batteries to 100%, verified charge and voltage several > times during charging: > Voltages (disconnected and tested with multimeter) and charge state (via > battery in-built display (25/50/75/100)) were consistent. > > -Disconnected powersupply: > Chargepower display went to zero, supplying power went to one (for the > slots with battery connected). > > > Roughly verified: > ================= > -Temperature (ambient, rising during charging). > -CycleCount: 2, consistent with a few checks at the manufacurers. > > > Not Tested: > =========== > -Behavior during discharge. > -Multiple charge/discharge cycles. > > > Questions: > ========== > -"ManufactureDate (16 bits): 3824" > Is there a way to decode this to a human readable date? > -------------------------------------------------------------------------- -- -------------------------------------------------------------- Tobias Kaupp Research Fellow, PhD The Australian Centre for Field Robotics The Rose St Building, J04 The University of Sydney, NSW 2006 Australia Phone: +61 2 9036 7057 Fax: +61 2 9351 7474 Email: t....@ca... Web: http://www.cas.edu.au/content.php/232.html?personid=45 -------------------------------------------------------------- |