[Gearbox-commit] SF.net SVN: gearbox: [170] gearbox/trunk/src/gbxgarminacfr

[<rus...@us...>]

Revision: 170
          http://gearbox.svn.sourceforge.net/gearbox/?rev=170&view=rev
Author:   russo2503v
Date:     2008-06-08 23:34:23 -0700 (Sun, 08 Jun 2008)

Log Message:
-----------
more more mroe debug

Modified Paths:
--------------
    gearbox/trunk/src/gbxgarminacfr/driver.cpp
    gearbox/trunk/src/gbxgarminacfr/nmea.cpp

Modified: gearbox/trunk/src/gbxgarminacfr/driver.cpp
===================================================================
--- gearbox/trunk/src/gbxgarminacfr/driver.cpp	2008-06-09 05:52:41 UTC (rev 169)
+++ gearbox/trunk/src/gbxgarminacfr/driver.cpp	2008-06-09 06:34:23 UTC (rev 170)
@@ -285,7 +285,7 @@
         // This will block up to the timeout
         //
         tracer_.debug( "Driver::read(): calling serial_->readLine()", 10 );
-        int ret = serial_->readLine(serialData);
+        int ret = serial_->readLine( serialData );
     
         // get time stamp right away (Linux only!)
         timeval now;
@@ -330,7 +330,7 @@
             if ( nmeaFailChecksumCount++ < nmeaFailChecksumMaxCount ) {
 //                 tracer_.warning("Gps driver: Single message failed checksum. Not throwing an exception yet!" );
                 // debug
-                cout<<now.tv_sec<<" "<<now.tv_usec<<" "<<nmeaFailChecksumCount<<" '"<<nmeaMessage.sentence()<<"'"<<endl;
+                cout<<now.tv_sec<<" "<<now.tv_usec<<" "<<nmeaFailChecksumCount<<" sentence='"<<nmeaMessage.sentence()<<"' raw='"<<serialData<<"'"<<endl;
                 continue;
             }
             else {

Modified: gearbox/trunk/src/gbxgarminacfr/nmea.cpp
===================================================================
--- gearbox/trunk/src/gbxgarminacfr/nmea.cpp	2008-06-09 05:52:41 UTC (rev 169)
+++ gearbox/trunk/src/gbxgarminacfr/nmea.cpp	2008-06-09 06:34:23 UTC (rev 170)
@@ -92,12 +92,13 @@
     switch ( AddOrTestCheckSum )
     {
         case TestChecksum:  { 
-            //This is for Rx'd data that we need to test for correct reception
+            // This is for Rx'd data that we need to test for correct reception
+            // (internally it will also call addCheckSum())
             testChecksumOk(); 
             break;
         }
         case AddChecksum: {  
-            //This is for Tx data that needs to checksummed before sending
+            // This is for Tx data that needs to checksummed before sending
             addCheckSum(); 
             checkSumOK_ = true; 
             break;


This was sent by the SourceForge.net collaborative development platform, the world's largest Open Source development site.