cue and room with a single audio board

Brought to you by: davebenson, geoff

cue and room with a single audio board

Forum: Open Discussion

Creator: Massimiliano Galanti

Created: 2000-10-22

Updated: 2001-05-17

Massimiliano Galanti - 2000-10-22

i am using GDAM on a laptop and obviously i can't fit an extra audio board. would it be possible to assign 'cue' to one channel (e.g. left) and 'room' to the other one? The balance effect provides some rough support for this trick but it's too messy to switch all these buttons... maybe this is possible by providing additional mono dsps devices which then feed the 'real' dsp... but how?

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
- geoff matters - 2001-05-17
  
  this behavior is available in gdam-0.938
  
  run gdam-launcher with "--define mono_cue"
  and the room/cue icons will move a source between
  left and right channels.
  
  -geoff
  
  If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.